Filter
Top Products
12 ST/SV-3210 and ST/SV-3306
3.2.2 SV Models
n Plug in and turn ‘On’ the printer.
o Place fanfold ticket stock in the bottom of the enclosure, bring the
stock up to the Media Guides. (The TOF Mark should be facing
away from the Printhead Latch; see Section 4.) Ensure that the
Printhead Latch is locked.
p Loosen the Thumbscrew and adjust the Media Guides to fit the width
of the ticket stock as described in Step 5 of Section 3.2.1.
q Slide the ticket stock through the Media Guides. The motor will
start; continue feeding the tickets. The printer will grab the leading
edge of the stock and complete the positioning process. If this
process fails, see the note below.
; Notes: If automatic loading fails to occur, see the note at the end of
Section 3.2.1.
If the ticket did not feed to a proper position, the TOF Sensor
may need adjustment; see Section 4 for details.