Filter
Top Products
23 Appendix B. Management protocols
Appendix B. Management protocols
Before using your network printer/MFP, you may need to check or configure
some parameters using management protocols.
DHCP/BOOTP
Dynamic Host Configuration Protocol (DHCP) is a communication protocol
enabling network administrators to centrally manage and to automate the
assignment of IP addresses in a network. In an IP network, each device needs
a unique IP address. DHCP lets a network administrator supervise and
distribute IP addresses from a central point and automatically sends a new IP
address when a device is plugged into a different place in the network.
Bootstrap Protocol (BOOTP) is UDP/IP-based protocol which allows a
booting host to configure itself dynamically and without user supervision.
BOOTP provides means to notify a host of its assigned IP address, the IP
address of a boot server host, and other configuration information, such as the
local subnet mask, the local time offset, and the addresses of default routers.
Addresses of various Internet servers can also be transferred to a host using
BOOTP.
DHCP is active by factory default on your network print server. After boot up,
the network print server will get an IP address automatically from the DHCP
server, if one exists. To set an IP address manually, see User’s Guide.
Configuring DHCP/BOOTP
To enable or disable DHCP/BOOTP, use one of printer/MFP’s control panel
or
Embedded Web Service
(EWS).
HTTP
Hypertext Transfer Protocol (HTTP) is an application layer protocol for
distributed, collaborative, hypermedia information systems. It is a generic,
stateless protocol which can be used for many tasks beyond its use for
hypertext, such as with name servers and distributed object management
systems. You are using HTTP when you connect your network printer via a
web browser.
The network interface card has a built-in web server, EWS. You can configure
and manage your network print server through Embedded Web Service using
HTTP over TCP/IP.