Filter
Top Products
Appendix I. Regulatory statement 61
Conformity assessment procedures for final products exempted from
R&TTE Directive Article 3.2
In every case, the manufacturer of a final product must follow the procedures
for conformity assessment of the final product with the requirements of
R&TTE Directive Article 3.1(a) and (b), for safety and EMC. The conformity
assessment for Article 3.2 is carried out in accordance with the following:
1) Attach the EN 300 328 test report of the assessed radio module and the EC
Declaration of Conformity to the conformity assessment of the final product
(The Declaration of Conformity is attached to the manual).
2) Specify on the conformity assessment of the end product that the assessed
radio module was integrated in the system without any changes, in
accordance with the installation directions of the manufacturer.
Notification of the final product
Please note that this product, DELL5002, uses radio frequency bands not
harmonized throughout the Community. The notification required by
R&TTE Directive Article 6(4) is necessary. It is the responsibility of the
manufacturer of the final product to notify the relevant national spectrum
management authority of the intention to place the final product on the
market.
CE marking
It is necessary to attach the CE mark to the final product to indicate that it
conforms with all the directives that apply to the final product. It must be
given a Class Identifier (alert symbol) in addition to the CE mark.