Filter
Top Products
Removing and Installing Parts 155
6
Remove the two screws securing the CD/DVD drive.
7
Slide the CD/DVD drive out through the front of the computer.
8
If you are not replacing the drive, replace the drive panel insert
(see "Replacing the Drive Panel Insert" on page 150).
9
Replace the drive panel (see "Drives" on page 138).
10
Replace the bezel (see "Replacing the Bezel" on page 137).
11
Replace the computer cover (see "Replacing the Computer Cover" on
page 176).
12
Connect your computer and devices to electrical outlets, and then turn
them on.
13
Configure the drives in system setup (see "Entering System Setup" on
page 188).
Installing a CD/DVD Drive
1
Follow the procedures in "Before You Begin" on page 105.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 107).
3
Remove the bezel (see "Removing the Bezel" on page 136).
4
Gently slide the drive into place.
5
Align the screw holes in the CD/DVD drive with the screw holes in the
CD/DVD drive bay.
6
Replace and tighten the two screws securing the CD/DVD drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board connector on the system board.
book.book Page 155 Monday, October 6, 2008 11:28 AM