Filter
Top Products
1 M2.5 x 6-mm screws (6)
2 LED cable
3 palm-rest flex cable
9. Remove the six M2.5 x 6-mm screws that secure the palm rest to the system board.
10. Disconnect the LED and palm-rest flex cables.
11. If a Mini PCI wireless card is installed, disconnect the two wireless cables
from the card.
12. Lift the palm rest away.
Replacing the Palm Rest
To aid with proper flex cable connection, a white locator line has been added near the ends of the flex cables. When replacing
the LED and palm-rest flex cables, press the cable into the connector until the white line disappears and hold it steady while
you snap the flex cable connector down. (The white line may reappear after the connector is closed; this should not indicate a
problem with the connection.)
Back to Contents Page