Filter
Top Products
Back to Contents Page
RemovingandReplacingParts:Dell™Dimension™2100SystemReference
Overview
Unless otherwise noted, each of the following procedures assumes:
l You have the recommended tools.
l You have performed the steps in "Precautionary Measures."
l You have removed the computer cover.
l You can replace or reinstall a part by performing the removal procedure in reverse order.
Precautionary Measures
Before you remove or replace parts in the computer, read the following caution for your personal safety and to prevent damage to the computer
from electrostatic discharge (ESD).
After you remove or replace parts in the computer, observe the following notice to prevent damage to the computer:
Recommended Tools
l Small flat-blade screwdriver
Overview
Hard Drive
Precautionary Measures
Power Supply and Fan Assembly
Recommended Tools
Control Panel
Cover
Cards
Rotating the Power Supply
Memory
Front panel
Heat Sink
3.5-Inch Front Panel Insert
Microprocessor
Upper 3.5-Inch Drive
Battery
Lower 3.5-Inch Floppy Drive
System Board
5.25-Inch Drive
CAUTION FOR YOUR PERSONAL SAFETY AND PROTECTION OF THE EQUIPMENT.
Before you start to work on the system, perform the following steps in the sequence listed:
1. Turn off your computer and all devices.
2. Ground yourself by touching an unpainted metal surface at the back of the computer before touching anything inside
your computer.
While you work, periodically touch an unpainted metal surface on the computer to dissipate any static electricity that
might harm internal components.
3. Disconnect any devices connected to the computer, including the monitor, from their electrical outlets to reduce the
potential for personal injury or shock. Also, disconnect any telephone or telecommunication lines from the computer.
4. Disconnect the power cable to your computer, and then press the power button to ground the system board.
NOTICE: Make sure that all other computer cables are connected before connecting the computer to its electrical outlet.