Dell Dimension 2100 Personal Computer User Manual


  Open as PDF
of 44
 
Back to Contents Page
SystemCodesandMessages:Dell™Dimension™2100SystemReference
Diagnostic Codes
Your computer is equipped with four diagnostic code lights, which are labeled "A," "B," "C," and "D" on the back of the computer. Each of the four
lights can be yellow, green, or off, as shown in Table 1. When the computer is turned on or restarted and is functioning normally, the lights flash
during power-on self-test (POST). After the computer starts, the lights remain green to signify normal computer operation.
If a malfunction is detected and the computer fails to start, the lights display a code that identifies the problem. Write down the diagnostic code
displayed and look it up in Table 1.
Table 1. Diagnostic Codes
Diagnostic Codes
POST Beep Codes
System Messages
Diagnostic Code
Definition
Corrective Action
Power up default.
Make sure that the computer is
connected to a known working
electrical outlet, and then check
whether the front-panel power light is
on or off. If the power light is off,
check the power supply. If the
problempersists,see"Contacting
Dell" in the Solutions Guide for
instructions on obtaining technical
assistance.
Remove all cards.Ifthecomputerstill
doesnotstart,see"ContactingDell"
in the Solutions Guide for instructions
on obtaining technical assistance.
System board is receiving power,
but the BIOS is not executing.
Set the configuration jumper to
Maintenance mode, and restart the
computer. Enter the system setup
program and ensure that the
processor speed is set correctly. Exit
and save the setting. Turn off the
computer, reset the configuration
jumper to Normal mode, and then
restart the computer. Remove all
cards and restart the computer to
determine if a resource conflict
exists. If a conflict exists, resolve the
conflict.
Iftheproblempersists,see
"Contacting Dell" in the Solutions
Guide for instructions on obtaining
technical assistance.
Recovery mode from BIOS failure.
Set the configuration jumper to
Maintenance mode, and restart the
computer. Enter the system setup
program and ensure that the
processor speed is set correctly. Exit
and save the setting. Turn off the
computer, reset the configuration
jumper to Normal mode, and then
restart the computer. If the problem
persists, see"ContactingDell"inthe
Solutions Guide for instructions on
obtaining technical assistance.
 previous next