Filter
Top Products
Installing System Components 105
Figure 3-18. Installing and Removing the Heat Sink
10
Rotate the processor shield upward and out of the way. See Figure 3-19.
11
Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
NOTE: In single-processor configurations, a processor must be installed in socket
CPU1. Install the blank in socket CPU2 only.
1 heat sink heat-sink 2 retention screws (4)
2
1
book.book Page 105 Wednesday, May 12, 2010 9:26 PM