Filter
Top Products
5. Check all connectors to ensure that they are properly cabled and firmly seated.
6. Replace the computer cover.
7. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Adding a Second Hard Drive (optional)
1. Check the documentation for the drive to verify that it is configured for your computer.
2. Follow the procedures in "Before You Begin."
3. Remove the plastic guide bracket from the inside of the hard-drive bay by gently pulling the bracket up and out of the bay.
4. Snap the bracket to the hard drive.
5. Gently slide the new drive (second hard drive) into place until you hear a click or feel the drive securely installed.
6. Connect a power cable to the drive.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
1
primary hard drive in upper bay
2
secondary hard drive in lower bay
3
rail tabs (2)
4
hard drive bay