Filter
Top Products
3. Disconnect the USB cable on the back of the Media Card Reader from the FlexBay USB connector on the system board and route the cable through the
clip on the shroud.
4. Grasp the sliding plate lever and push it towards the base of the computer; then, hold it in place while you slide the Media Card Reader from the
computer.
5. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
6. Replace the drive panel.
7. Replace the computer cover.
8. Connect your computer and devices to their electrical outlets, and turn them on.
1
cables
2
Media Card Reader (not present on all computers)
1
sliding plate lever
2
sliding plate
3
Media Card Reader
NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.