Filter
Top Products
Back to Contents Page
Battery Pack
Alienware®M14x Service Manual
Removing the Battery Pack
Replacing the Battery Pack
Removing the Battery Pack
1. Follow the instructions in Before You Begin.
2. Remove the base cover (see Removing the Base Cover).
3. Disconnect the battery-pack cable from the connector on the system board.
4. Loosen the two captive screws that secure the battery pack to the computer base.
5. Using the pull-tab, lift the battery pack off the computer base.
Replacing the Battery Pack
1. Follow the instructions in Before You Begin.
2. Place the battery pack in the battery bay and tighten the two captive screws that secure the battery pack to the computer base.
3. Connect the battery-pack cable to the connector on the system board.
4. Replace the base cover (see Replacing the Base Cover).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid damage to the computer, use only the battery designed for this particular Alienware computer. Do not use batteries designed
for other Alienware computers.
1
battery pack
2
pull-tab
3
captive screws (2)
4
battery-pack cable
CAUTION: To avoid damage to the computer, use only the battery designed for this particular Alienware computer.