Configuring L2 Bridge Mode | 44
7. Select the group from the Product Group drop-down list.
The product group setting specifies the mysonicwall users
who can upgrade or modify the appliance.
8. Click Register.
Configuring L2 Bridge Mode
This section provides instructions to configure the Dell
SonicWALL NSA E8510 appliance in tandem with an existing
Internet gateway device. This section is relevant to users
following deployment scenario C.
This section contains the following sub-sections:
• Connection Overview - page 44
• Configuring the Primary Bridge Interface - page 45
• Configuring the Secondary Bridge Interface - page 45
Connection Overview
Connect the X1 port on your Dell SonicWALL NSA E8510 to the
LAN port on your existing Internet gateway device. Then
connect the X0 port on your NSA E8510 to your LAN resources.
If You Are Following
Scenario...
Proceed to Section:
B - NAT with State Sync Pair Additional Deployment Configuration -
page 45
E8510
Network Security Appliance
10GE
SonicWALL NSA E-Class
Network Gateway
L2 Bridge Link
Network Resources
X1
LAN
X0
Internet or
LAN Segment 2