Filter
Top Products
Adding and Replacing Parts 181
6
Lift the WLAN card from the computer at a 45-degree angle.
Replacing a WLAN Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
NOTICE: To avoid damage to the WLAN card, never place cables under the card.
1
Insert the
WLAN
card connector into the system board connector labeled
"WLAN" at a 45-degree angle by aligning the notch on the WLAN card to
the slot on the system board connector.
2
Press down the other end of the WLAN card and tighten the screw
securing the card to the system board.
book.book Page 181 Wednesday, September 16, 2009 11:12 AM