Filter
Top Products
Removing and Installing Parts 69
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you
apply equal force to each end of the module.
4
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
5
Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the
computer.
6
Connect your computer and devices to electrical outlets, and turn them on.
7
Right-click the
My Computer
icon and click
Properties
.
8
Click the
General
tab.
9
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1
Follow the procedures in "Before You Begin" on page 61.
2
Press out the securing clip at each end of the memory module connector.
3 Grasp the module at the end of the board and lift up.
book.book Page 69 Monday, July 23, 2007 3:47 PM