Dell WorkStation 410 Personal Computer User Manual


 
9-6
'HOO3UHFLVLRQ'HVNWRS6\VWHPV8VHU©V*XLGH
5HPRYLQJDQ([SDQVLRQ&DUG
Follow this general procedure to remove an expansion card:
 ,I\RXDUHUHPRYLQJDQRQ3OXJDQG3OD\,6$H[SDQVLRQFDUGHQWHUWKH
,&8DQGUHPRYHWKHH[SDQVLRQFDUGIURP\RXUFRQILJXUDWLRQ
See Chapter 4, “Using the ISA Configuration Utility,” for instructions.
 5HPRYHWKHFRPSXWHUFRYHUDFFRUGLQJWRWKHLQVWUXFWLRQVLQ´5HPRYLQJ
WKH&RPSXWHU&RYHUµLQ&KDSWHU
&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWURVWDWLF'LVFKDUJHµLQWKHVDIHW\
LQVWUXFWLRQVDWWKHIURQWRIWKLVJXLGH
 ,IQHFHVVDU\GLVFRQQHFWDQ\FDEOHVFRQQHFWHGWRWKHFDUG
 8QVFUHZWKHPRXQWLQJEUDFNHWRIWKHFDUG\RXZDQWWRUHPRYH
 *UDVSWKHFDUGE\LWVRXWVLGHFRUQHUVDQGHDVHLWRXWRILWVFRQQHFWRU
 ,I\RXDUHUHPRYLQJWKHFDUGSHUPDQHQWO\LQVWDOODPHWDOILOOHUEUDFNHW
RYHUWKHHPSW\FDUGVORWRSHQLQJ
NOTE: Installing filler brackets over empty card-slot openings is necessary to
maintain Federal Communications Commission (FCC) certification of the system.
The brackets also keep dust and dirt out of your computer.
 5HSODFHWKHFRPSXWHUFRYHUDQGUHFRQQHFW\RXUFRPSXWHUDQGSHULSK
HUDOVWRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
$/(57&RYHUZDVSUHYLRXVO\UHPRYHG
 7RUHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRUHQWHUWKH6\VWHP6HWXSSURJUDP
DQGUHVHW&KDVVLV,QWUXVLRQWR1RW'HWHFWHG
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
$GGLQJ0HPRU\
Dell Precision 410 systems can use unbuffered or registered synchronous dynamic
random-access memory (SDRAM) modules that provide error checking and correction
(ECC) capabilities.
23186bk0.bk Page 6 Thursday, October 29, 1998 11:07 AM