10-14
'HOO3UHFLVLRQ'HVNWRS6\VWHPV8VHU©V*XLGH
)LJXUH$WWDFKLQJ+DUG'LVN'ULYH&DEOHV
,IWKHRWKHUHQGRIWKH(,'(FDEOHLVQRWDOUHDG\FRQQHFWHGFRQQHFWLWWR
WKH,'(FRQQHFWRURQWKHV\VWHPERDUG
&$87,21<RXPXVWPDWFKWKHFRORUHGVWULSRQWKH(,'(FDEOHZLWKSLQ
RQWKH,'(FRQQHFWRUWRDYRLGSRVVLEOHGDPDJHWR\RXUV\VWHP
To locate the IDE1 connector, see Figure 9-1.
5HSODFHWKHFRPSXWHUFRYHU7KHQUHFRQQHFW\RXUFRPSXWHUDQGSHULSK
HUDOVWRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
$/(57&RYHUZDVSUHYLRXVO\UHPRYHG
,QVHUWDERRWDEOHGLVNHWWHVXFKDVWKH
'HOO'LDJQRVWLFV'LVNHWWH
LQWR
GULYH$
(QWHUWKH6\VWHP6HWXSSURJUDPDQGXSGDWHWKHDSSURSULDWH'ULYH
FDWHJRU\RUXQGHU'ULYHV3ULPDU\
See “Drives: Primary and Secondary” in Chapter 3.
:KLOH LQWKH6\VWHP6HWXS SURJUDPUHVHWWKH FKDVVLVLQWUXVLRQGHWHFWRU
E\FKDQJLQJ&KDVVLV,QWUXVLRQWR1RW'HWHFWHG
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
After you update the System Setup settings, reboot the system.
EIDE
cable
power input connector
on drive
IDE1
connector
IDE2
connector
DC power cable
interface connector
23186bk0.bk Page 14 Thursday, October 29, 1998 11:07 AM