Dell WorkStation 410 Personal Computer User Manual


  Open as PDF
of 238
 
Using the ISA Configuration Utility 4-1
&+$37(5
8VLQJWKH,6$&RQILJXUDWLRQ8WLOLW\
The ISA Configuration Utility (ICU) is used by the system to track what expansion
cards are installed and what resources are used. With this information, the system
automatically configures Plug and Play expansion cards and Peripheral Component
Interconnect (PCI) expansion cards and can tell you how to configure non-Plug and
Play Industry-Standard Architecture (ISA) expansion cards manually by setting jump-
ers or switches. Plug and Play and PCI expansion cards do not contain jumpers and
switches; they are configured only through software in the basic input/output system
(BIOS).
&$87,217KH,&8LVLQWHQGHGRQO\IRUFRQILJXULQJQRQ3OXJDQG3OD\,6$
H[SDQVLRQFDUGV,WVKRXOGQRWEHXVHGIRUDVVLJQLQJUHVRXUFHVWR3OXJDQG
3OD\H[SDQVLRQFDUGVDQG3&,H[SDQVLRQFDUGV7KHVHFDUGVVKRXOGEHFRQ
ILJXUHGDXWRPDWLFDOO\E\WKH%,26
NOTE: The Windows NT operating system does not provide full Plug and Play sup-
port. Therefore, some Plug and Play cards (such as modem, sound, and network
cards) may not work with Windows NT. If your system is running a Dell-installed
Windows NT operating system and you want to use Plug and Play cards, Dell
recommends that you use the card manufacturer’s configuration utility to set the card
to legacy mode, enter the card’s resources through the manufacturer’s utility, and
then use the ICU to add the Plug and Play card to your system configuration. On sys-
tems with a Dell-installed Windows NT operating system, the ICU is installed on the
hard-disk drive as a diskette image. Use the Program Diskette Maker (located in the
Dell Accessories program folder) to make an ICU diskette from this diskette image.
The remainder of this chapter describes the various features of, and the various ways
to use, the ICU.
23186bk0.bk Page 1 Thursday, October 29, 1998 11:07 AM
 previous next