Filter
Top Products
Quick Start
Quick Start
Quick Start describes how to prepare the Twin Client Manager and the Denso terminal
for a Telnet session with the host. Following an initial serial download, the terminal
software and configuration is managed automatically, over the wireless network.
Note: Denso terminals are normally delivered with Denso files pre-installed.
Configuring the Manager
The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on Start, Programs, PowerNet, and Twin Client Manager. Select the Settings
menu.
Click on
Emulation, select the desired emulation, and click on OK.
Setting the Servers
The Servers are the Telnet host systems the terminals will access.
Supported Equipment Manual
•
March, 2006
2-5