Filter
Top Products
Standard Setup
Host 0
IP 206.183.67.155
Port 23__
<F3> Save <F7> Quit
Press F3 to save the configurations.
Edit License Key
The client software can be authorized automatically, as described in the next section,
Authorizing PowerNet. This menu option permits authorization of each terminal
manually. Select this option to obtain the terminal's Identification Code, which is used to
obtain the Authorization code from the Connect web site, as described in the next section.
The 12-digits displayed at the terminal screen top is the terminal’s Identification Code.
00A0F826E614
Authorization
______________
not authorized
<F3> Save <F7> Quit
Type the authorization code into the field as it appears on the web site. Punctuation
characters, such as the hyphen (-), are required. Press
F3 to save the authorization code.
Run Site Survey
This option (a feature of Spectrum 1) is applicable to Release 5.0 and may be obsolete for
your terminal.
Switch Client Modes
The PowerNet Twin Client normally operates in Telnet mode, which provides direct
connection to Telnet hosts. It can also operate in Server mode, through a PowerNet
OpenAir server. Select this menu option to switch between Server and Telnet modes of
operation. Note that the host socket address for the PowerNet OpenAir servers is 1800,
which must also be changed in the
Edit Server/Host IPs menu described above.
Run Client Emulator
After all desired changes have been made, select this option to return to the Twin Client
main menu. Then press any key to establish the Telnet session and begin emulation.
Refer to the Quick Start 3 sub-section, Starting a Telnet Session, for further instructions.
Setting Default Executable
From the System Menu, press <4> Set System and press <1> Execute Program.
Supported Equipment Manual
•
March, 2006
2-25