Filter
Top Products
Quick Start
Starting a Telnet Session
Press <1> Execute Program.
SYSTEM MENU
1: EXECUTE PROGRAM
2: DOWNLOAD
3: UPLOAD
4: SET SYSTEM
5: TEST
6: VERSION
7: FTP
8: RF
Select an emulation and press Enter.
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction on the session time. The instructions for
authorizing the terminal are presented in Authorizing PowerNet.
Note:
In order to run Twin Client, the heap area must be set up as follows.
(This is valid for the BHT7500 only.)
Start system menu ([SF]?[1]+[PW])
Select set system menu ([4]?[ENT])
Select heap size set menu ([SF]+[1])
+--------------------------+
|SET FOR RUNNING C PROGRAMS|
| 1:HEAP SIZE [ 76]KB |
| (in 4KB units) |
| MIN : 76KB |
| MAX : 140KB |
Set heap size as 140KB
?push [ENT] (cursor move to ])
?push [C] (70 is turn off)
?push [1]?[4]?[0]?[ENT]
?push[C] to system menu
Supported Equipment Manual
•
March, 2006
2-17