Filter
Top Products
Configuration through the web interface
152
Alarm destinations
The Alarm Destination part of the page defines how alarm notifications are sent—either
as an email message or an SNMP trap, or both—and where the alarm notification is sent.
Send E-mail to the following recipients when alarm occurs: Select the
checkbox to specify that the alarm should be sent as an email message. Then
specify the following information:
– To: The email address to which this alarm notification email message will be
sent.
– CC: The email address to which a copy of this alarm notification email
message will be sent (optional).
– Priority: The priority of the alarm notification email message.
– Subject: The text to be included in the Subject: line of the alarm-notification
email message.
Send SNMP trap to the following destination when alarm occurs: Select the
checkbox to specify that the alarm should be sent as an SNMP trap.
For alarms to be sent as SNMP traps, the IP address of the destination for the
SNMP traps must be specified in the SNMP settings. This is done on the
System Configuration pages of the web interface. See "SNMP configuration
settings" on page 153. That destination IP address is then displayed below the
“Send alarm to SNMP destination” checkbox.
To configure an alarm notification to be sent as both an email message and an
SNMP trap, select both Send E-Mail and Send SNMP trap checkboxes.
Click Apply to apply changes for the alarm and return to the Alarms
Configuration page.
Enable and Disable Alarms
Once alarm conditions are configured, enable and disable individual alarms by selecting
or deselecting the Enable checkbox for each alarm.