Filter
Top Products
Configuration through the web interface
154
Destination IP: The IP address of the system to which traps are sent. In order
to enable any of the traps, a non-zero value must be specified. For Digi devices
that support alarms, this field is required in order for alarms to be sent in the
form of SNMP traps. See "Configure alarms" on page 149.
At the bottom of the page are checkboxes for the SNMP traps that can be used:
authentication failure, login, cold start, and link up traps.
Configure remote management (Connectware Manager) settings
The Remote Management configuration page sets up the connection to the Connectware
Manager server so the Digi device knows how to connect to the server.
The Connectware Manager server allows devices to be configured and managed from
remote locations.
Steps for setting up remote management
Using Connectware Manager as a remote manager of a Digi device requires several steps:
1 Install The Connectware Manager server on a server system. See the Connectware
Manager Getting Started Guide for installation instructions
2 Assign a device ID defined for the Digi device. See the Connectware Manager
Operator’s Guide’s instructions for adding a device.
Important: The device ID for the Digi device must be unique. By default, the
device ID is created from the MAC address of the device.
3 From the web interface, configure the Remote Management settings so the device
can communicate with the Connectware Manager server.
There are two pages of remote management settings: Connections and
Advanced settings.