Filter
Top Products
DGS-3100 Series Firmware Release Notes
10
v3.00.43
1
Modify Safeguard Engine
command to support defining threshold
l config safeguard_engine {state [enable | disable] | {rising
<value 20-100> | falling <value 20-100>}}
2 Modify the command “show_safeguard” to “show
safeguard_engine”
3 Remove “enable safeguard” and “disable safeguard” commands
4 Modify Traffic Segmentation command to support configuring
multiple source and forwarding ports
l config traffic_segmentation [<portlist> | <ch1-32>]
forward_list [<portlist> | <ch1-32>]
5 Modify Spanning Tree command to support configuring recovery
timer for ports which are shut down by loop
l config stp {maxage <value 6-40> | maxhops <value 1-20> |
hellotime <value 1-10> | forwarddelay <value 4-30>| fbpdu
[enable | disable] lbd [enable | disable] |
lbd_recover_timer [<value 30-86400>]}
6 Modify Port Security command to support lock_address_mode’s new
parameters
l [<portlist> | all] {admin_state [enable | disable] |
max_learning_addr <int 1-64> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset] | trap
<interval 1-1000000>}
v2.50.43
1
Change the command
“
config guest vlan
”
to
“
create 802.1x
guest_vlan”
2 Change the command “config guest_vlan ports” to “config 802.1x
guest_vlan ports”
3 Change the command “show guest_vlan” to “show 802.1x
guest_vlan”
4 Change the command “config rate_limit” to “config
bandwidth_control”
5 Change the command “show rate_limit” to “show
bandwidth_control”
6 Modify “config snmp system_contact” command’s parameter
l Describe the allowable character number: <sw_location 0-31>
7 Modify “config snmp system_name” command’s parameter
l Describe the allowable character number: <sw_name 0-31>
8 Change the command “show cpu utilization” to “show utilization”
and also add one more parameter
l Support two parameters: [ports | cpu]
9 Modify the parameter for “traceroute” command.
l change the packet size from “[size 40-1500]” to “[size
40-1472]”