Filter
Top Products
DGS-3100 Series Firmware Release Notes
14
configured as a LACP port. The
LACP configuration does not take
effect.
3
The
user can configure illegal IP
address for several features, like “Trust
Host”, “Syslog”, “SNMP”, “SNTP”,
“Radius” and “ARP”, without any
warning message.
There is no problem if the user
configures correct IP addresses
4
When configuring “ipif”, th
e switch
displays ''system'' but not ''System''
It is displaying problem and no
effect on the functionality.
5
Dynamic
VLAN
is
not displayed in the
VLAN page when the browser is in
security level high or medium-high.
It was tested with IE7, it works
fine if lowering browser’s security
level
6
If the user configures port security on
specific ports via the CLI and
configures trap on these ports and
afterwards configures port security on
other ports from the web without a
trap, using the show port_security and
show configuration running commands
on CLI, the user can see that the trap
appears also on the ports configured by
via the web (without a trap)
None
7
When user tries to show VLAN, STP and
GVRP information via CLI, the ‘q’
button does not interrupt the
displaying when you type it. For
example: when you typed "show
GVRP ?", the PORTLIST + LAG list was
printed, typed "q" to stop displaying
but the rest of the LAGs were printed
any way.
It does not affect the switch
functionality.
8
QoS
does not work
properl
y when using
queue 3 across the stack. It happens in
strict priority and also in WRR. When
the user does not use queue 3
everything works fine.
Do not use queue 3 under
stacking topology
* D-Link tracking number is enclosed in ()
Related Documentation:
- DGS-3100 Series User Manual v3.6
- DGS-3100 Series CLI Manual v3.6
- DGS-3100 Series Hardware Installation Guide v3.5