Filter
Top Products
DGS-3100 Series Firmware Release Notes
6
14
C
hange the Web UI login behavior for user level
autho
rization
15 Expand the Trust Host number to 10 and support the Trust Host
Network feature
16 The Web UI will display the trap interval in Port Security Page.
17 Be able to configure Destination Lookup Failure (DLF) for ports
18 Be able to configure the recovery time when port is shut down by
loop
v2.50.43
1
MLD Snooping v1 and v2
2 Time Based ACL
3 Enable/Disable Telnet Server
4 LLDP
5 IGMP Querier
6 Display switch’s serial number on the Web UI and CLI
7 VLAN Trunking
When enabling this feature, DGS-3100 will pass the traffic with
unknown VID to VLAN trunking port instead of dropping it.
8 Be able to configure Traffic Segmentation on Management VLAN
9 Be able to configure ACL on Link Aggregation Port
10 Be able to configure port speed and duplex mode on a Link
Aggregation Trunk channel group
11 The EAP packet from clients will be flooded by default
12 Be able to configure port without assigning stacking ID
13 Keep the default route setting when management IP changed
14 The unregistered multicast group will be flooded by default
15 Disable the Spanning Tree Protocol by default
16 When loop is detected, the port will be shut down and after a period
of time, the port will automatically recover
17 Change the port displaying format. The above figure is the old format and
the below one is the latest format.