Filter
Top Products
DGS-3100 Series Firmware Release Notes
11
v2.00.47 None
v1.00.36
(DGS-3100-24/48)
v1.00.37
(DGS-3100-24P/48P)
First release
Problem Fixed:
Firmware Version
Problems Fixed
v3.60.28
1 The “Time Zone Offset” cannot be changed via Web GUI but there is no
problem for CLI command. (DRU20100318000003)
2 User cannot add a VLAN name with space in CLI but no problem for Web
GUI (DI20100209000008)
v3.50.23
1 The “Port ID” and “Port ID Subtype” in the LLDP TLV information display
Hex string in Web UI instead of displaying alphanumeric one.
(DI20090330000015)
2 The stack cannot be established due to that the switch’s MAC overlapped.
(DI20091208000009)
v3.00.43
1 If user changes switch’s unit ID to 2 and queries the ifTable MIB file,
system will hang up.
2 When user tries to disable Telnet via the Web UI while running the
command “show configuration running”, the Telnet session will not be
disabled and there is no warning message, either.
3 When user tries to configure 128.0.0.0 subnet mask in Trusted Host
feature, the CLI will accept the command but Web UI will display
“128.0.0.0 is not a valid IP mask” warning message.
4 In Port Security, when user changes the setting of “lock_address_mode”,
the value of “admin_stat” will be changed, too.
v2.50.43
1 When executing the command ‘configure ipif’ and key in the ‘?’ to query
the next available parameter, it will display ‘system’ instead of ‘System’.
2 Users can only open two web sessions in stacking architecture.
3 Users can configure the stacking port as the LACP port.
4 When configuring Trust Host, Syslog, SNMP, SNTP, Radius and ARP
features; Illegal IP address is acceptable without any error or warning
message.
5 When user configures port security with trap enabled on specific ports via
CLI and afterwards configures port security on other ports with no trap
enabled via Web UI, using the ‘show port_security’ or ‘show configuration
running’ commands on CLI, the user can see that the trap appears also