Filter
Top Products
DSL-604+ ADSL Ethernet Router User’s Guide
21
In the Multiple PVC configuration menu configure the WAN interface settings described in the table below.
ALL CONNECTIONS MUST CONFIGURE:
Select index to set Choose the index number you wish to modify or delete.
Item Name Type in a new name for this profile.
VPI Type in the new VPI setting (0-255)
VCI Type in the new VCI setting (32-65535)
Encapsulation
From the drop-down menu select PPPoE LLC, PPPoA LLC,
PPPoA VC mux, IPoA LLC, IPoA VC mux, Bridge LLC, or Bridge VC
mux. Default for Index 1 = PPPoA LLC.
PPP Connections must configure:
Login User Name Used for authentication by your network service provider.
Login Password Used for authentication by your network service provider
Confirm Password Type the same password to confirm it.
Authentication
Protocol used to confirm the identity of the subscriber. Choose chap
(default) or pap form the drop-down menu.
Connect on Demand
Select enabled or disabled. When this function is enabled the router will
connect any workstation on your LAN to the Internet upon request. If this
function is disabled, it will be necessary to access this menu and hit the
Connect button each time you want to establish a connection to the
WAN or the Internet.
Idle Time
A value of 0 means that the PPP connection will remain connected. If
your network account is billed according to the amount of time the
Router is actually connected to the Internet, enter an appropriate Idle
Time value (in seconds). This will disconnect the Router after the WAN
connection has been idle for the amount of time specified. The default
value = 0.
IPoA Connections must configure:
IP Unnumbered
This is enabled by default and therefore no IP settings need to be
entered for the account. If this is disabled, (global) IP settings must be
configured for the WAN interface.
IP Address
If IP Unnumbered is disabled, type in the WAN IP address for the
account.
Subnet Mask
If IP Unnumbered is disabled, type in the subnet mask for the WAN
interface.
WAN Connection Configuration
Connect / Disconnect
If you have enabled the Connect on Demand feature, the Router will begin to negotiate the WAN connection
upon restarting. If the Connect on Demand feature has been disabled, click the Connect button to initiate the
connection via the ADSL WAN interface. The process will take a few seconds. To end the WAN connection,
click on the Disconnect button.