Filter
Top Products
5 Configuration D-Link Web Smart Switch User Manual
NOTE: The switch proceeds the access rule from
the smallest access ID, so be careful in assigning
the ID for the expected results.
To modify an existing rule, please click on the Access ID hyperlink.
Figure 103 – ACL > Access Profile List > Access Rule List
ACL > ACL Finder
This page is used to help find a previously configured ACL entry. To search for an entry, enter the profile ID
from the drop-down menu, select a port that you wish to view, define the state and click Find. The table on
the lower half of the screen will display the entries. To delete an entry click the corresponding Delete button.
Figure 104 – ACL > ACL Finder
PoE > PoE Port Settings (Only for DES-1210-28P)
DES-1210-28P supports Power over Ethernet (PoE) as defined by the IEEE specification. IEEE 802.3at
Ports 1-4 can provide up to 30watts of power per port and IEEE 802.3af ports 5-24 provide up to 15.4watts
to PDs (Powered Device) over Category 5/5e or Category 3 UTP Ethernet cables. DES-1210-28P follows the
PSE (Power Supply Equipment) standard pinout Alternative A, whereby power is sent out over pins 1, 2, 3
and 6.
As per the IEEE 802.3af standard, the PSE provides power according to the following classification:
Class Usage Maximum power used by PD
0 Default 15.4W
1 Optional 4.0W
2 Optional 7.0W
3 Optional 15.4W
4 Reserved 15.4W~30W
As seen in the following figure, the PoE port table displays the PoE status including, Port Enable, Time
Range, Priority, Power Limit, Power(W), Voltage(V), Current(mA), Classification and Port Status. You
can select From Port / To Port to control the PoE functions of a port. DES-1210-28P will auto disable the
ports if the power of a portis over 350mA, while the other ports stay active.
NOTE: The PoE Status information Power
Voltage and Current is the power usage
information of the connected PD; please click
Refresh to renew the information.
6
6
3
3