Filter
Top Products
6 Command Line Interface D-Link Web Smart Switch User Manual
6 Command Line Interface
The D-Link Web Smart Switch allows a computer or terminal to perform some basic monitoring and
configuration tasks by using the Command Line Interface (CLI) via TELNET protocol.
To connect a switch via TELNET:
1. Make sure the network connection between the switch and PC is active.
2. To connect, launch any terminal software like HyperTerminal in Microsoft Windows, or just use the
command prompt by typing the command telnet followed by the switch IP address, eg. telnet 10.90.90.90.
3. The logon prompt will appear.
Logging on to the Command Line Interface:
Enter your User Name and Password to log in. The default user name and password is admin. Note that the
user name and password are case-sensitive. Press Enter in both the Username and Password fields. The
command prompt will appear as shown below (DES-1210-28>):
DES-1210-28P login: admin
Password:
DES-1210-28P>
Figure 112 – Command Prompt
The user session is automatically terminated if idle for the login timeout period. The default login timeout
period is 5 minutes. To change the login timeout session please refers to chapter 5.
CLI Commands:
There are a number of helpful features included in the CLI. Enter the ? command will display a list of
commands.
DES-1210-28P> ?
USEREXEC commands :
config account admin password <passwd>
config ipif System { ipaddress <ip-address> <subnet-mask> gateway <gw-
address> | dhcp }
debug info
download { firmware_fromTFTP tftp://ip-
a
ddress/filename | cfg
_
fromTFTP
tftp://ip-address/filename }
logout
ping <ip_addr> [times <integer (1-255)>] [timeout <integer (1-99)>]
reboot
reset config
save
show ipif
show switch
upload { firmware_toTFTP tftp://ip-
a
ddress/filename | cfg
_
toTFTP
tftp://ip-address/filename }
DES-1210-28P>
Figure 113 – The ? command
Download
The download command is used to download and install new firmware or a Switch configuration file
from a TFTP server.
Syntax
download { firmware_fromTFTP tftp://ip-address/filename | cfg_fromTFTP
tftp://ip-address/filename}
Parameters
Parameter Description
6
6
7
7