Filter
Top Products
VPN-PPTP Settings
The Point-to-Point Tunneli
establishing a secure tunne
The PPTP Settings page allows you to enable or disable PPTP on the DFL-
600.
ng Protocol (PPTP) is another method of
l between the DFL-600 and a remote gateway.
PPTP Pass Through
ation computer on
our LAN. When IPSec Pass-through is
P packets
Click Enable to allow PPTP packets to pass
through the router to the destin
y
enabled, the DFL-600 will allow PPT
to reach their destination computer on your
LAN.
PPTP Status
PPTP can be Enabled or Disabled by clicking
the appropriate click-box and the clicking the
Apply.
Starting IP Address
pecify a range of IP
ddresses for clients on your network that can
P
ng
lds.
This allows you to s
a
use the PPTP protocol. If you have only one I
address, enter this address in both the Starti
IP Address and Ending IP Address fie
Ending IP Address
his allows you to specify a range of IP
that can
enter this address in both the Starting
IP Address and Ending IP Address fields.
T
addresses for clients on your network
use the PPTP protocol. If you have only one IP
address,