Filter
Top Products
Using the Configuration Interface
39 D-Link Systems, Inc.
Inbound Filters
The Inbound Filters option is an advanced method of controlling data received from the Internet. With
this feature you can configure inbound data filtering rules that control data based on IP Address,
Protocol, and/or Port.
The Inbound Filter option is best suited for custom applications. For most applications you should use
Virtual Server, Special Applications, or the Gaming section to create rules that will allow applications
to communicate through the router.
Add/Edit Inbound Filter Rule
Enables inbound filtering.
Enter a name for the rule that is meaningful to you.
The rule can be set to either allow or deny applicable messages.
Defines the range of Internet addresses this rule applies to.
Select the protocol used for this rule.
Enter the range of ports that this rule applies to.
Enter the range of WAN side ports associated with the servers on the LAN
that this rule applies to.
Select a schedule for the times when this rule should be in effect. If you do
not see the schedule you need in the list of schedules, go to the Tools >
Schedules screen and create a new schedule.
Check this option if you want the router to add an entry to the log whenever
a rule is enforced.
Saves the new rule or modified existing rule to the Rules list. When you are
done editing the settings, you must click the Save Settings button at the top
of the page to make the changes effective and permanent.
Inbound Filter Rules List
This section lists the current Inbound Filter rules. Entries can be modified by clicking on the paper
and pencil icon. To delete an entry, click on the trash can icon. After you’ve completed all modifications
or deletions, you must click the Save Settings button at the top of the page to save your changes.
The router must reboot before new settings will take effect. You will be prompted to Reboot the
Device or Continue. If you need to make additional settings changes, click Continue. If you are
finished with your configuration settings, click the Reboot the Device button.
Enable:
Name:
Action:
Source IP Range:
Protocol:
Source Port Range:
Public Port Range:
Schedule:
Log:
Save:
Advanced > Inbound Filters