Filter
Top Products
Using the Configuration Interface
41 D-Link Systems, Inc.
Advanced > Advanced Wireless
Fragmentation
Threshold:
RTS Threshold:
Beacon Period:
DTIM Interval:
802.11d Enable:
WDS Enable:
WDS AP MAC Address:
Advanced Wireless
Advanced Wireless Settings
This setting should remain at its default setting of 3200. If you experience a
high packet error rate, you may slightly adjust your “Fragmentation” value
somewhere in the between the recommended range of 256 to 3200. Setting
the Fragmentation value too low may result in poor performance.
This setting should remain at its default setting of 3200. If you encounter
inconsistent data flow, only minor modifications to the value are
recommended.
Beacons are packets sent by a wireless router to synchronize wireless
devices. Specify a Beacon Period value between 20 and 1000. The default
value is set to 100 milliseconds.
The default value is set to 1. Valid settings are between 1 and 255. A DTIM
is a countdown informing clients of the next window for listening to broadcast
and multicast messages. When the wireless router has buffered broadcast
or multicast messages for associated clients, it sends the next DTIM with a
DTIM Interval value. Wireless clients hear the beacons and awaken to receive
the broadcast and multicast messages.
This enables 802.11d opration. 802.11d is a wireless specification developed
to allow implementation of wireless networks in countries that cannot use
the 802.11 standard. This feature should only be enabled if you are in a
country that requires it.
When WDS is enabled, this access point functions as a wireless bridge and
is able to wirelessly communicate with other AP’s via WDS links.
Note: WDS is incompatible with WPA. Both features cannot be used at the
same time. A WDS link is bidirectional so this AP must know the MAC address
(creates the WDS link) of the other AP, and the other AP must have a WDS
link back to this AP (the router).
Specifies one-half of the WDS link. The other AP must also have the MAC
address of this AP (the router) to create the WDS link back to the router.