Filter
Top Products
12D-Link ShareCenter DNS-345 User Manual
Section 2 - Getting Started
This User Guide will help you get your ShareCenter set up in just a few steps. To install the ShareCenter on your local network,
refer to the steps below, or skip to page 16 to run the setup wizard which will show you how to install and congure your
DNS-345.
Getting Started
Hardware Setup
Step 1 - Remove the front panel by rmly
gripping the panel and sliding it up until it
unhooks. Then remove it to allow access to
the drive bays.
Step 2 - Insert up to four 3.5” SATA hard
drives into the drive bays.
Note: Make sure to align the drive connector to the SATA connector at the back edge inside the drive bay of the ShareCenter.
Gently push the drive in until it connects. When a drive is inserted properly, you will feel it “set” into the connector. Some hard
drives that are thin or oddly shaped may need to be inserted carefully into position. If a drive is not properly set in place, the
hard drive icon will not illuminate on the OLED screen after powering on the device.