Filter
Top Products
Using the add Command
D-Link Unified Wired and Wireless Access System
November 7, 2011 Page 16
D-Link UAP CLI Command Reference
Using the add Command
The add command enables you to add a new instance or group of instances of a class and has the following
syntax:
add unique-named-class instance [property value ... ]
add group-named-class instance [property value ... ]
add anonymous-class [property value ... ]
For example:
add mac-acl default mac 00:01:02:03:04:05
Using the remove Command
The remove command enables you to remove an existing instance of a class. It has the following syntax:
remove unnamed-class [property value . . . ]
remove named-class instance | all [property value . . .]
For example:
remove mac-acl default mac 00:01:02:03:04:05
Additional CLI Commands
The CLI also includes the following commands for maintenance tasks:
Note: To add an instance to a uniquely named class, you must assign the instance a name that is not
already in use by another instance of that class. If you add instances to group-named classes, you can
form groups by creating instances and assigning them identical names. All instances of a group-named
class that have the same name form a group of instances.
Table 2: Additional CLI Commands
Command Description
save-running
The save-running command saves the running configuration as the startup
configuration.
For more information, see “Saving Configuration Changes” on page 21.
reboot
The reboot command restarts the access point (a “soft” reboot).
factory-reset
The factory-reset command resets the AP to factory defaults and reboots.
firmware-upgrade
Use the firmware-upgrade command to upload a new AP image.
config
Use the config command to upload or download the AP configuration file.