Filter
Top Products
Radio Settings
D-Link Unified Wired and Wireless Access System
November 7, 2011 Page 26
D-Link UAP CLI Command Reference
Radio Settings
Table 8 shows the Radio commands. The commands in this table use radio one (wlan0). To change the wireless
settings for radio two, use
wlan1.
Set DNS name servers to use static IP
addresses (dynamic to manual mode).
set host dns-via-dhcp down
set host static-dns-1 ip_address
set host static-dns-2
ip_address
Example:
set host static-dns-1 192.168.23.45
Set DNS name servers to use DHCP IP
addressing (manual to dynamic mode).
set host dns-via-dhcp up
Set the IPv6 admin mode.
set management ipv6-status {up | down}
Set the IPv6 autoconfig admin mode.
set management ipv6-autoconfig-status {up | down}
Set the static IPv6 address.
set management static-ipv6 ipv6_address
Set the static IPv6 prefix length.
set management static-ipv6-prefix-length 0–128
View the IPv6 autoconfigured global
addresses.
get management autoconfig-ipv6-global-all
Set the default IPv6 Gateway.
set static-ipv6-route gateway ipv6_address
Table 8: Radio Settings Commands
Action Command
View a description of the radio interfaces.
get radio all description
Turn the radio on/off.
set radio wlan0 status {on | off}
Enable or disable 802.11d regulatory domain
support.
set dot11 dot11d {up | down}
Enable or disable station isolation.
set radio wlan0 station-isolation {on | off}
View the current radio mode.
get radio wlan0 mode
Set the radio mode to IEEE 802.11a.
set radio wlan0 mode a
Set the radio mode to IEEE 802.11a/n.
set radio wlan0 mode a-n
Set the radio mode to IEEE 802.11b/g.
set radio wlan0 mode bg
Set the radio mode to IEEE 802.11b/g/n
set radio wlan mode bg-n
Set the radio mode to 2.4 GHz IEEE 802.11n.
set radio wlan0 mode n-only-g
Set the radio mode to 5 GHz IEEE 802.11n .
set radio wlan0 mode n-only-a
View the radio channel.
get radio wlan0 channel
Set the radio channel to a static channel.
set radio wlan0 channel-policy static
set radio wlan0 static-channel channel
Set the radio channel to “auto”
set radio wlan0 channel-policy best
Table 7: Ethernet Settings Commands (Cont.)
Action Command