Filter
Top Products
14
Setting up the Projector
FIGURE 12
Connecting the projector to a video player using an S-video cable and the A/V cable
4
Plug the A/V cable’s white connector into the left “audio out”
connector on your video player. Plug the cable’s red connector
into the right “audio out” connector on the video player (Fig-
ure 11 and Figure 12).
5
Plug the A/V cable’s other white and red connectors to the
left and right In ports on the projector.
CAUTION: Your video player
may also have a “Video Out”
connector for a coaxial cable
connection. DO NOT use this to
connect to the projector.
The projector is compatible with these major broadcast video
standards: NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60, and
SECAM. It automatically adjusts to optimize its performance for
the incoming video. The input signal for SECAM video is similar
to other video signals and cannot be automatically detected,
therefore SECAM must be chosen manually. See “Video Stan-
dard” on page 35 for details.
Connecting a Video Player using BNC Cables
Connect the BNC cables and audio cables to the appropriate con-
nectors on the projector (Figure 8 on page 10) and on your video
player.
This input is designated Component Video.
L L
Inout InIn
L
BNC BNC
R RR
A
0
A
0
R
s
R
G
G
B
B
A/V cable
S-video
cable