Filter
Top Products
35
Controls Menu
FIGURE 26
Controls menu
Video Standard
NOTE: If you already know the
video standard used in your geo-
graphical area, it’s often best to
manually select it.
When Video standard is set to Auto, the projector attempts to
pick the video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-
N,PAL-60, or SECAM) automatically based on the input signal it
receives. (The video standard options may vary depending on
your region of the world.) The input signal for SECAM video is
similar to other video signals and cannot be automatically
detected, therefore SECAM must be chosen manually. If the pro-
jector is unable to detect the correct standard, the colors might
not look right or the image might appear “torn.” If this happens,
manually select a standard by clicking the left or right mouse but-
ton and cycling through the standards.
Standby Time
This option lets you select how long the lamp stays on and the
blank screen is displayed when the projector enters standby
mode before the projector turns off. Select among instant, 1, 5, 10,
15 and 30 minutes and 1 and 2 hours by clicking the left or right
mouse button and cycling through the options.
Display Audio Image Controls Language Status
>
>
Video standard
Standby time 1 minute
Ceiling projection off
Rear projection off
Default source computer VESA
Auto source select off
Plug and Play off
USB: Mouse Button left/right
USB: Inhibit Screen Saver off
Display messages on
Display startup screen on