Filter
Top Products
Page 24
iQ Series, Auto User’s Manual
Dukane Manual Part No. 403-573-02
Connecting Cables
For stand-alone modules and securely installed panel
mounted modules:
Rear Connections
Refer to Figure 3-4 below. Complete these connections.
1. Earth ground - Connect one end of a user-supplied
14-Gauge ground wire to the ground connection at
the rear of the MPC - A in Figure 3-4. Connect the
other end of the wire to an earth ground potential at
the electrical box that supplies power to the equipment
(or to the equipment enclosure into which your system
is installed).
2. U/S (ultrasonic) cable (Dukane P/N 200-479-XX -
Order the correct cable length for your installation.)
- Connect one end of the cable to the left rear U/S
connector of the MPC module- B in Figure 3-4. The
other end of the cable connects to J1 of the ultrasonic
generator.
3. MPC Interface cable (Dukane P/N 200-1408-XX -
Order the correct cable length for your installation.)
- Connect one end of the cable to the right rear MPC
Interface connector- C in Figure 3-4. The other end
of the cable connects to the MPC INTERFACE con-
nector on the ultrasonic generator.
Figure 3-4 MPC Module Rear Connectors
CA
B
Figure 3-5 MPC Module Front Connectors
D
System Frequency Probe P/N Cable P/N : MPC to Probe
20kHz 41Q20RE or 41Q20RS 200-479-XXM
30kHz 41A60E or 41A60S 200-479-XXM
40kHz 41A40 200-615-XXM
Front Connections
Refer to Figure 3-5 below. Complete these connections.
1. Probe Cable(s) - Beginning with PROBE 1, connect
one end of the cable (See Table 3-IV below.) to the U/S
connector on the MPC’s front panel - D in Figure 3-5.
Connect the other end of the cable to the corresponding
probe for your specic welding application.
2. Repeat Step 1 for each of the remaining probes (in
sequence: 2, 3, 4, etc.) in your system.
Table 3-IV Probe Cables
XX = length in meters