Filter
Top Products
Page 32
iQ Series, Ultrasonic Hand Held Systems User’s Manual
Dukane Manual Part No. 403-583-00
Hold
HOLD is used more often with Time or Energy modes, but
it can be used with the Automation mode.
HOLD does not allow the automation program to begin a
new cycle until HOLD is nished.
To set a HOLD period:
1. Select the weld mode (Automation, Time, Energy).
2. Set the time and energy parameters as needed.
3. Press the HOLD key. The screen will appear as it
does in Figure 5-9.
4. Set the time with the
+ -
keys.
(A maximum of 5.0 seconds.)
Figure 5-9A shows a setting for 2.0 seconds.
5. Press the ENTER key to conrm your selection.
Amplitude Adjustment
Amplitude refers to the movement of the horn at its
workface. The higher the amplitude setting, the higher the
power output level will be at a particular pressure level.
Amplitude settings are given as a percent of the horn’s
nominal amplitude in the range of 20% to 100%.
It is typical to leave the amplitude setting at 100% for
maximum power output.
To adjust amplitude:
1. Press the AMP key. The screen will appear as in
Figure 5-10.
2. Set the amplitude level using the keys and the
+ -
keys.
3. Press ENTER to conrm your amplitude setting.
Hold Time
OFF S
Figure 5-9 HOLD Time - 1
Amplitude
100 %
Figure 5-10 Amplitude
Hold Time
2.0 S
Figure 5-9A HOLD Time - 2