Filter
Top Products
Connecting to the Audio Interface
Connecting to the Audio Interface
The AudioFire2, AudioFire4, AudioFire8 and AudioFire12 audio interfaces
contain a wide variety of connections that allow great flexibility in operation. For
optimal performance, it is critical to use the appropriate cabling and connectors.
Analog Inputs and Outputs – AudioFire2
AudioFire2’s front panel has two analog line inputs (1 – 2), an amber power
indicator light, and an 1/8” stereo headphone output jack, with a corresponding
volume knob, which monitors analog outputs 3 and 4, labeled “Headphones” in the
AudioFire Console. The analog inputs operate with an input impedance of
10Kohms.
AudioFire2 has two analog line outputs on the rear panel. The input and output
connections can be used with balanced or unbalanced cables via the ¼” connectors.
By default, the inputs and outputs are set to receive or send a +4dBu signal.
You can switch between +4dBu and –10dBV for each individual input and output
via the console software (see section below).
14
Connecting to the Audio Interface