Filter
Top Products
2.1.3 Remote Management
The remote management function allows you to designate a host in the Internet the ability to configure the Broadband
router from a remote site. Enter the designated host IP Address in the Host IP Address field.
Parameter Description
Host Address
This is the IP address of the host in the Internet that will have management/configuration
access to the Broadband router from a remote site. This means if you are at home and
your home IP address has been designated the Remote Management host IP address
for this router (located in your company office), then you are able to configure this router
from your home. If the Host Address is left 0.0.0.0 this means anyone can access the
router’s web-based configuration from a remote location, providing they know the
password.
Click the Enabled box to enable the Remote Management function.
Note: When you want to access the web-based management from a remote site, you
must enter the router’s WAN IP address (e.g. 10.0.0.1) into your web-browser followed
by port number 8080, e.g. 10.0.0.1:8080 (see below). You’ll also need to know the
password set in the Password Setting screen in order to access the router’s web-based
management.
Port The port number of remote management web interface.
Enabled Select “Enabled” to enable the remote management function.
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance sections
or start using the router (with the advance settings in place)
2.2 WAN
Use the WAN Settings screen if you have already configured the Quick Setup Wizard section and you would like to change
your Internet connection type. The WAN Settings screen allows you to specify the type of WAN port connect you want to
establish with your ISP. The WAN settings offer the following selections for the router’s WAN port, Dynamic IP, PPPoE,
PPTP, Static IP Address, L2TP, Telstra Big Pond, DNS and DDNS.
21