Filter
Top Products
20
Pages 29, 30
4. Adjust the angle
5. Adjust the focus and the zoom
Page 31
8. Turn the power off
Page 28
7. Select the input mode
Page 36
11
11
1 Press FOCUS +/– on the projector or on the remote control to adjust the focus.
22
22
2 Press ZOOM +/– on the projector or on the remote control to adjust the zoom.
Press INPUT on the projector or COMPUTER1 on the remote control to select the “COMPUTER1” mode.
••
••
• When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode and then press ENTER.
••
••
•
When using the remote control, press COMPUTER1/2, DVI, HDMI, VIDEO or S-VIDEO to switch the input mode.
Press STANDBY-ON on the projector or on the remote control. While the confirmation message is displayed,
press STANDBY-ON again.
••
••
• You can unplug the power cord even if the projector is operating.
••
••
• Even if you unplug the power cord from the AC outlet, the cooling fan continues to run for a while.
Adjust the projector angle:
••
••
•
Shift the lens horizontally and vertically.
11
11
1
Press H&V LENS SHIFT on the projector or
on the remote control.
22
22
2
Press
', ", \ or |
on the projector or the
remote control.
••
••
•
Adjust the projector angle by rotating the adjust-
ment feet.
6.
Correcting the image distortion due to the projection angle
11
11
1 Press KEYSTONE on the projector or on the remote control.
22
22
2 Press ENTER on the projector or on the remote control.
33
33
3 Press ', ", \ or | to move the position for the upper left of the image.
44
44
4 Press ENTER to set the position.
55
55
5
Repeat the same procedure with the positions for the upper right, lower right and lower left of the image.
••
••
•
When the position of the lower left is set, the correction is made and the display disappears.
Page 32
""
""
" On-screen display
On the
projector
On the remote
control
INPUT list On-screen display (RGB)
Quick Start