Filter
Top Products
28
Turning the Projector On/Off
Info
• When “Auto Restart” is set to “On”:
If the power cord is unplugged from the AC outlet or the
breaker switch is turned off when the projector is on,
then the projector automatically turns on when the power
cord is plugged into the AC outlet or the breaker switch
is turned on. (See page 63.)
• English is the factory preset language. If you want to change
the on-screen display to another language, change the lan-
guage according to the procedure on page 65.
▼On-screen display
Power cord
Supplied
accessory
Connecting the Power Cord
Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into the AC outlet.
Turning the Projector On
Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 24–27.)
Remove the lens cap and press STANDBY-
ON on the projector or on the remote con-
trol.
• The power indicator illuminates red.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
• When System Lock is set, the keycode input
screen appears. Enter the right keycode to
start projection. See page 60 for details.
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green: The lamp is on.
Blinking green: The lamp is warming up.
Red:
The lamp is shut down abnormally
or the lamp should be replaced.
•
When switching on the projector, a slight flick-
ering of the image may be experienced within
the first minute after the lamp has been illumi-
nated. This is normal operation as the lamp’s
control circuitry is stabilizing the lamp output
characteristics. This does not indicate malfunc-
tion.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Turning the Power Off
(Put-
ting the Projector into Standby Mode)
Press STANDBY-ON on the projector or
on the remote control, then press that
button again while the confirmation mes-
sage is displayed, to put the projector
into standby mode.
Power cord
To AC outlet
To AC socket
Rear view
Lens cap
STANDBY-ON
button
Lamp indicators1, 2
Power indicator
STADNBY-ON button
Info
• You can unplug the power cord from the AC outlet even if
the cooling fan is still running. Even if you unplug the power
cord from the projector, the cooling fan continues to run
for a while.