Filter
Top Products
48
Maintenance and Cleaning
When the life of the projection lamp of this projector draws
to an end, the LAMP REPLACE indicator lights yellow. If
this indicator lights yellow, replace the lamp with a new one
promptly.
Follow these steps to replace the lamp.
Lamp
Lamp Cover
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool, for at least 45 minutes
before you open the Lamp cover. The inside of
the projector can become very hot.
POWER
WARNING
LAMP
REPLACE
V
O
L
U
M
E
+
SELECT
Top Control
CAUTION
Screw
Screw
Turn off the projector and disconnect the AC plug.
Allow the projector to cool for at least 45 minutes.
Loosen 2 screws of the lamp with a screwdriver and
pull out the lamp by grasping the handle.
1
3
Replace the lamp with a new one and tighten the 2
screws back into position. Make sure that the lamp is
set properly. Replace the lamp cover and tighten the
screw.
4
Loosen the screw with a screwdriver, and remove the
lamp cover.
2
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the Lamp replace counter.
See “Lamp Replace Counter” on the next page .
5
Lamp Replacement
Handle
Screw
CAUTION
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
This indicator is yellow
when the life of the
projection lamp draws to
an end.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector : LC-XB28
● Replacement Lamp Type No. : POA-LMP55
(Service Parts No. 610 309 2706)