eMachines ET1160 Series Personal Computer User Manual


 
Chapter 4: Upgrading Your Computer
38
4 Slide the tabs of the new color panel up into the slots
on the front bezel.
5 Press firmly on the lower left and lower right parts of the
color panel to engage the panel’s internal locking tabs.
You should press the two points against the computer
until you hear or feel a click, which is the sound of the
panel’s internal locking tabs locking the panel partially
into place.
6 While pressing the bottom center of the color panel
against the front bezel, slide the panel release lever back
to the right. The color panel is now fully locked into place.
Installing memory
When you upgrade the computer memory, make sure that you
install the correct type of memory module for your computer.
Your computer uses DIMM memory.
To install or replace DIMM memory:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 33.
2 For more stability, place your computer on its side. To
avoid scratching the case, place it on a towel or other
non-abrasive surface.
3 Find the memory module banks on your system board.
8513152.book Page 38 Wednesday, May 14, 2008 4:57 PM