Filter
Top Products
3
Configuring a CLARiiON Boot Device
3-27
Configuring an EMC Boot Device
Installing Additional
Navisphere Host
Agent Software
The EMC ControlCenter Navisphere Host Agent should be used to
automatically register host connections with the array. PowerPath
and ATF require different registration types and the Navisphere Host
Agent is the preferred method over manual registrations.
You should install the Navisphere Host Agent software to ensure the
HBA connections are all registered correctly. For instructions on how
to perform this operation refer to the EMC ControlCenter Navisphere
Host Agent software documentation for your array type.
After the host agent has started and registered the new HBA paths,
you should refresh the host connections in the storage group to
ensure all available paths are assigned. To do this:
1. Shut down the host.
2. Remove the host from the storage group.
3. Apply the change.
4. Add the host back into the storage group.
5. Restart the host.
6. Check the array connectivity status to ensure all connections you
require are active.
Configuring
Additional Boot Port
Name Entries in the
Boot BIOS
To take advantage of the high-availability features of the HBA boot
BIOS, you must configure additional Boot Port Name entries in the
BIOS for any additional SP ports from which you want the BIOS to
attempt to boot during system startup. Depending on the failover
software installed, follow the appropriate steps:
1. Reboot the host
When the QLogic BIOS banner (shown below) appears, press
CTRL–Q.
Different HBA models may display different banners. Be sure to select
CTRL-Q for the HBA you wish to configure.
QLogic Corporation
QLA2300 PCI Fibre Channel ROM BIOS Version 1.17
Copyright © Qlogic Corporation 1993-1999 All rights reserved
Press <CTRL - Q> for Fast!UTIL
www.qlogic.com