Filter
Top Products
Quick Installation Guide
00825-0100-4075, Rev BA
February 2010
Smart Wireless THUM Adapter
20
Troubleshooting
If the device is not operating properly, refer to the troubleshooting section of the manual. The
most common cause of incorrect operation is the Network ID and Join Key. The Network ID
and Join Key in the device must match that of the Smart Wireless Gateway.
The Network ID and Join Key may be obtained from the Smart Wireless Gateway on the
Setup>Network>Settings page on the web server. The Network ID and Join Key may be
changed in the wireless device by using the following Fast Key sequence.
REFERENCE INFORMATION
NOTE:
In order to communicate with a Field Communicator, the wired device must be
powered.
Table 1. THUM Adapter Fast Key Sequence
Function Key Sequence Menu Items
Wireless Setup 1, 4 Smart Power, Network ID, Set Join
Key, Radio State
Function Key Sequence Menu Items
Device Info 2, 2, 4, 3 Manufacturer, Model, Final Assembly Number, Universal,
Field Device, Software, Hardware, Descriptor, Message,
Date, Model Number I, II, III, SI Unit Restriction, Country
Guided Setup 2, 1 Configure, Guided Setup, Join Device to Network,
Configure Update Rate, Zero Trim, Configure Device
Display, Configure Process Alarms
Manual Setup 2, 2 Configure, Manual Setup, Wireless, Pressure, Device
Temperatures, Device Information, Display, Other
Wireless 2, 2, 1 Network ID, Join Device to Network, Configure Update
Rate, Configure Broadcast Power Level, Power Mode,
Power Source
4075_QIG_Rev_BA.fm Page 20 Friday, February 19, 2010 11:08 AM