Filter
Top Products
Installation
5
Figure 4 Communication cable connection
2.5 Mounting the RMP on Drywall
To hang the RMP on drywall or similar surface:
1. Drill four holes (6mm-by-26mm) in the wall, spacing them as shown in Figure 5.
2. Insert the four factory-supplied, plastic anchors into the holes.
3. Insert one screw into each anchor and tighten firmly.
4. Remove the four hooks from the RMP, reverse them, then reattach them to the RMP.
5. Hang the RMP on the wall by slipping the hooks over the heads of the screws and lowering the
RMP slowly until the screws are seated in the slotted portion of the hooks.
Figure 5 Mounting hole dimensions
UPS_U2_J24
Up to 328ft. (100 m)
RMP_X1_J1
Shield
Shield
485-
485+
485-
485+
1
2
3
4
1
2
3
4
STATUS
Remote Monitor Panel
S ILE NC E ON/ OFF
Liebert NX
Emerson
Network Power
TM
14-3/16"
(365mm)
12"
(306mm)
F1 F2
F4F3 HELP