Filter
Top Products
SS-100 Serial Server Configuring the SS-100 • 5
word (system is the default password) and click
Login:
3.1. TCP/IP Setup
1. Click the TCP/IP link from the list along the left-
hand side of the Home screen:
2. Contact your Network Administrator to go
through the following steps. (Steps correspond to
letters A, B, C, D, E, and F on the graphic
below):
A. Specify the IP address.
B. Set RARP, BOOTP, and DHCP as specified by
the Network Administrator. Enabling these set-
tings may randomly change the IP address on
boot-up.
C. Configure the gateway address in the Gateway
Address field specific to the customer's network
as specified by the Network Administrator.
D. Configure the subnet mask in the Gateway
Address field specific to the customer's network
as specified by the Network Administrator.
E. Configure backup gateway in the Backup Gate-
way field specific to the customer's network as
specified by the Network Administrator.
F. Click Update Server Settings to save the TCP/
IP configuration.
3.2. Setting the Server Properties
1. Click the Server Properties link from the list
along the left-hand side of the screen.
Password Screen
NOTE: The Password screen appears only
once per session.
Home Screen
TCP/IP Settings
NOTE: The IP address of the device has now
changed. To connect to the new IP address,
type the IP address into the browser.