Filter
Top Products
Aurorean Network Gateway-1000 User’s Guide
7
Chapter 2 Connecting Power to the ANG-1000
Installation
Figure 7 Connecting Ethernet Cables to an ANG-1000
3 Plug an orange, straight-through Ethernet cable into the External port
as shown in Figure 7.
4 Plug the opposite end of this cable into a DSL or cable modem.
After you connect power, the top External LED at the rear of the
ANG-1000 will be lit the moment the cable it is connected.
NOTE
If you have a DSL modem, you will need to get an IP address from your
provider and configure it before the External LED will light. This
condition may also exist for selective cable customers. Some cable
internet providers require that you supply the MAC address of your
computer. Refer to Chapter 3 for directions.
Connecting Power to the ANG-1000
WARNING
To avoid electrical shock, connect the Aurorean system only to a
grounded (earthed) outlet.
Trusted
External
Optional crossover cable
for direct PC connection